Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3. Attach plate to flanged side of oil cooler core using suitable nuts, washers and bolts. PRESSURIZED AIR AND FLYING PARTICLES To avoid injury to eye or face, wear a face shield or goggles when conducting a pressure test. 4. Attach an air hose to the air hose fitting. 5. Regulate air pressure to 517-690 kPa (75-100 psi) and submerge the oil cooler and plate assembly in a container of water heated to 82°C (180°F). [a] Check for leaks as indicated by air bubbles in the water. [b] If leaks are indicated, replace the core. 6. After the pressure check is completed, remove the plate and air hose from the cooler core.

EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 7. Dry the core with compressed air. 3.8.4 Installation of Oil Cooler Install the oil cooler core as follows: 1. Lubricate new O-rings with a light coat of petroleum jelly. See Figure 3-25. 2. Install the new O-rings in the counterbores in the oil filter adaptor. 3. Coat the O-ring with ethylene glycol (coolant). 4. Install a new O-ring in the groove on the oil cooler housing outlet neck. 5. Install a new gasket on the face of the core that will contact the housing.

All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-57