3.9 OIL COOLER (PRE-1991 ENGINES) The coolant outlet oil cooler housing uses two large rubber O-rings seated in a groove in the outlet neck. See Figure 3-29. 1. Bolt, Oil Cooler Housing-to-Block (10) 5. O-rings, Large (2) 2. Gasket, Oil Cooler-to-Housing 6. Oil Cooler Housing 3. O-rings, Small (2) 7. Pipe Plugs (2) 4. Oil Cooler Figure 3-29 Oil Cooler Housing and Related Parts (Pre-1991 Engines) Two small O-rings are positioned in cylinder block counterbores to seal the lubricating oil passages between the block and the cooler core. The oil cooler housing is attached to the cylinder block.
The flow of oil is from the oil pump, through a vertical passage in the cylinder block, through the full-flow oil filters and then through the oil cooler core and the cylinder block main oil galleries. (Rev. 2005) All information subject to change without notice. 3-60 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION