3.9 OIL COOLER (PRE-1991 ENGINES) 3.9.2 Removal of Oil Cooler Remove the oil cooler core and housing as follows: PERSONAL INJURY To avoid injury from improper use of chemicals, follow the chemical manufacturer’s usage, handling, and disposal instructions. Observe all manufacturer’s cautions. PERSONAL INJURY To avoid injury when using chemical substances, it is essential to observe the manufacturer’s instructions for use, safety, and waste disposal. PERSONAL INJURY To avoid injury when using caustic cleaning agents, follow the chemical manufacturers usage, disposal, and safety instructions. NOTICE:
Do not attempt to clean an oil cooler when an engine failure releases metal particles from worn or broken parts into the lubricating oil. The oil cooler core must be replaced. Otherwise, severe engine damage may result. 1. Drain the cooling system by opening the drain cocks at the right rear of the cylinder block, and in the bottom of the water pump housing. (Rev. 2005) All information subject to change without notice. 3-62 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION