SERIES 60 SERVICE MANUAL 3.9.3.1 Inspection of Oil Cooler Inspect the oil cooler as follows: NOTICE: In cases where a leaking oil cooler core has caused contamination of the engine, the engine must be immediately flushed to prevent corrosion to its internal components. Refer to section 14.6.4. 1. Make a suitable plate and gasket using the oil cooler as a template. Use a gasket made from rubber to ensure a tight seal. 2. Drill and tap the plate prior to mounting to permit an air hose fitting to be attached at the inlet side of the core. See Figure 3-31. Figure 3-31 Preparing Oil Cooler Core for Pressure Test All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-65