SERIES 60 SERVICE MANUAL 3.9.4 Installation of Oil Cooler Install the oil cooler core as follows: 1. Lubricate the new O-rings with a light coat of petroleum jelly. 2. Install the O-rings in the counterbores in the cylinder block. 3. Replace the O-rings on the oil cooler housing outlet neck. 4. Coat the O-ring with ethylene glycol (coolant). 5. Install the O-ring in the groove on the oil cooler housing outlet neck. 6. Install the guide studs (J–35786) into two threaded holes in the cylinder block. See Figure 3-32. Figure 3-32 Oil Cooler Guide Stud Installation NOTICE:
Use care when installing the oil cooler housing to prevent damaging the outlet neck O-rings on the sharp edges of the opening in the cylinder block. Some cleaning of the block opening is usually needed. 7. Install a new gasket on the face of the core that will contact the housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-67