Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3.11.3 Cleaning of Oil Pan Clean the oil pan prior to inspection as follows: 1. Clean the oil pan and attaching hardware with clean fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry with compressed air. NOTICE: Do not use solvents to clean isolators. Damage to the isolator will result. 3. Clean the surfaces of the cylinder block, gear case and flywheel housing where they mate with the oil pan. 3.11.3.1 Inspection of Oil Pan Inspect the oil pan, inserts, bolt isolators and isolator seal as follows: 1.

Check for dryness, cracks or tears. [a] If isolator is damaged, replace with new part. [b] If isolator is not damaged, reuse the part. 2. Check oil pan inserts and nut assemblies for tightness. [a] If inserts and nut assemblies are loose, torque to 183-197 N·m (135-145 lb·ft). 3. Check oil pan for major dents, cracks and other damage. [a] If oil pan is damaged, replace with new part. [b] If oil pan is not damaged, reuse the part. 4. Check isolator seal for dryness, cracks or tears. [a] If seal is damaged replace with new part. [b] If seal is not damaged clean off excess RTV clean seal with clean fuel oil dry completely and reuse part. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-79