SERIES 60 SERVICE MANUAL 4.2 WATER PUMP (GEAR-CASE MOUNTED - 1991 AND LATER) (GCM) The centrifugal-type water pump circulates the engine coolant through the cooling system. The pump is mounted on the rear of the gear case on engines built after 6R37023, and is driven by the water pump drive gear. See Figure 4-5. The water pump drive gear meshes with the bull gear. The pump was mounted on the front of the gear case cover on units built prior to and including 6R37023. See Figure 4-32. Refer to section 4.3. Figure 4-5 Water Pump Mounting (1991 and Later Model) An impeller is pressed on one end of the stainless steel drive shaft.
The other end of this shaft has internal threads, and a retaining bolt secures the water pump drive gear to the shaft. Two tapered roller bearing assemblies are used to support the shaft. See Figure 4-6. An O-ring, located in a groove in the water pump housing, seals the water pump to the gear case. An O-ring, located under the water pump cover, seals the cover to the water pump housing. The water pump bearings are lubricated by splash oil through a passage from the front of the pump housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 4-7