Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

4.2 WATER PUMP (GEAR-CASE MOUNTED - 1991 AND LATER) (GCM) 4.2.2 Draining and Removal of Water Pump (GCM) Drain the cooling system as follows: Open the drain cocks located at the right rear corner of the engine, at the bottom of the water pump and in the bottom of the thermostat housing. Remove the water pump as follows: 1. Loosen the hose clamps and remove the coolant hoses from the water pump housing. 2. Loosen and remove the three water pump housing-to-gear case bolts. Remove the water pump from the engine by pulling it straight out of the gear case. 4.2.3 Disassembly of Water Pump (GCM) Disassemble the water pump as follows:

EYE INJURY To avoid injury from flying parts when working with components under spring tension, wear adequate eye protection (face shield or safety goggles). 1. Remove water pump cover snap ring with snap ring pliers, (J–22380) or equivalent. Remove water pump cover and seal ring. NOTICE: When clamping gears, use soft jaws on vise to prevent damage to the gear teeth. 2. Clamp the water pump drive gear in a vise with the impeller facing up. Use a two-screw gear puller and remove the water pump impeller from the shaft, using the two threaded holes in the impeller. (Rev. 2005) All information subject to change without notice. 4-10 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION