Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

4.2 WATER PUMP (GEAR-CASE MOUNTED - 1991 AND LATER) (GCM) NOTICE: The drive shaft must be installed using the outer bearing race only. Any other attempt at installation may damage the bearings. Figure 4-19 Drive Shaft Installation (GCM) 9. Press the drive shaft and bearing assembly into the water pump housing, using J–35988–1 (part of tool set J–35988–C) until it is seated firmly against the shoulder in the housing. 10. Install the snap ring to the water pump housing. See Figure 4-20. Figure 4-20 Snap Ring Installation (GCM) (Rev. 2005) All information subject to change without notice. 4-20 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION