SERIES 60 SERVICE MANUAL NOTICE: The hemispherical portion of the injector hold-down clamp washers must be installed facing the clamp (pointing down) in order to prevent damage to the washers. See Figure 1-46. 8. Visually inspect each injector hole tube to ensure they are clean. Install the fuel injectors. Refer to section 2.3.5. Be sure the injector hold-down clamps are clear of the valve and injector springs. Figure 1-46 Injector Hold-Down Clamp Washer Installation 9. Install the clamp bolts with hemispherical washers, torque to 58-66 N·m (43-49 lb·ft). 10. Install the camshaft. Refer to section 1.28.6. NOTE:
If a cylinder head other than the one removed from the engine, or if a resurfaced cylinder head is being installed, the three nuts retaining the adjustable idler gear must be loosened before installing and torquing the camshaft drive gear retaining bolt. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-57