SPECIFICATIONS This section contains the exceptions to the fastener torque specifications. Torque Specification Exceptions - Fasteners The proper bolt and nut torque is dependent on its size. The proper torque for metric nuts and bolts are listed in Table 1-35 in the "General Information" section at the beginning of this manual. The exceptions to this rule are listed in Table 4-2. Standard (nonmetric) nut and bolt torque specifications are listed in Table 1-37 in the "General Information" section at the beginning of this manual. EXCEPTIONS TO STANDARD FASTENER TORQUE SPECIFICATIONS Table 4-2 Exceptions - Metric Fastener Torque Specifications NOTE:
The water pump drive gear retaining nut is M24 X 1.0. PERSONAL INJURY To avoid injury from rotating belts and fans, do not remove and discard safety guards. (Rev. 2005) All information subject to change without notice. 4-86 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Bolt and Size, mm Torque, N · m Torque, lb · ft M24 X 1.0 203-230 150-170