Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Lubricants meeting these criteria have provided maximum engine life when used in conjunction with specified oil drain and filter maintenance schedules. Only oils licensed by API may be used in Detroit Diesel engines. Lubricants meeting API Service category CH-4 are intended for use primarily with low (0.05%) sulfur fuel and may be used in all Detroit Diesel Series 60 engines. API CG-4 and CF-4 oils may be used when CH-4 oils are not available; however, their use may require a reduction in oil drain interval depending upon the application and the fuel sulfur level.

At ambient temperatures below -20°C (-4°F) when sufficient starter speed cannot be achieved with SAE 15W-40 oils, the use of 5W-XX and 10W-XX oils, where XX is 30 or 40, may be used to improve startability provided they are API CH-4 and have demonstrated field performance in DDC engines. These oils must possess a HT/HS of 3.7 minimum. When the use of high sulfur fuel (greater than 0.5% mass sulfur) is unavoidable, higher alkalinity lubricants are recommended. High sulfur fuels require modification to oil drain intervals. For further information refer to section, "The Use of High Sulfur Fuels." All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 5-11