Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6.3.1 Repair or Replacement of Intake Manifold To determine if repair is possible or replacement of the intake manifold is necessary perform the following procedure. See Figure 6-6. Figure 6-6 Flowchart for Repair or Replacement of Intake Manifold 6.3.2 Removal of Intake Manifold Remove the intake manifold as follows: 1. Disengage the locking tang on the turbo-boost pressure sensor connector. Grasp the connector body and pull it straight out of the turbo-boost pressure sensor. 2. Remove the turbo boost sensor. Refer to section 2.23.2. 3. Remove air temperature sensor. Refer to section 2.27.2. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 6-11