SERIES 60 SERVICE MANUAL 6.3.4 Installation of Intake Manifold Install the intake manifold as follows: NOTICE: It is necessary to completely seal the intake manifold to the cylinder head, due to the high pressure of the intake charge provided by the turbocharger. The arrow on the gasket must point to the front of the engine. Gasket eliminator can not be used with intake manifold seals. Failure to seal this interface will reduce engine performance. 1. Install three new manifold gaskets to the mating surfaces of the intake manifold with the arrow on the gasket pointing to the front of the engine. See Figure 6-8. Figure 6-8 Intake Manifold Gasket Orientation 2.
Install bolts six and seven through the intake manifold and into the cylinder head and hand-tighten. See Figure 6-9. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 6-15