SERIES 60 SERVICE MANUAL The early and former tensioner assembly, support plate, and tensioner adjusting bolt are not separately interchangeable on a part-for-part basis and should not be used on an engine. To simplify installation of the DN alternator drive belt and ensure proper running tension throughout drive belt life, an auto belt tensioner assembly replaced the former tensioner/support plate assembly on December 15, 1997, effective with engine serial number 6R392714. See Figure 9-5. Use of the auto tensioner eliminates the need for periodic belt tension inspection. Only the auto belt tensioner assembly is used on engines with 50 DN alternators.
Figure 9-5 Auto Belt Tensioner Assembly with 50 DN Alternator Effective June 2000, the No. 4 size vent hose on the 50DN alternator was replaced by a No. 6 braided hose to improve venting of the alternator and extend alternator life. In addition, the vent line connection point on the engine was moved from a tapped hole in the gear case to a tapped hole in the auto belt tensioner mounting plate. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-9