Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 9.2.3.1 Checking Twin-Vee Belt Driven Alternator Belt Tension The recommended tension for new belts is 556 N (125 lb). However, because new belts lose tension rapidly during the first few minutes of operation, it is important to check the tension after running the engine for 10 to 15 minutes. To check belt tension, use the following procedure: NOTICE: Failure to properly orient the drive belt when installing it over the pulleys may result in belt damage at engine startup. PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked.

PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 1. Tension the new drive belts to 556 N (125 lb) using a belt tension tool (J–41251–B) or equivalent. 2. Start and run the engine from 10 to 15 minutes to allow the belts to warm up and seat in the pulley grooves. 3. Stop the engine, and allow it to cool for 10 to 15 minutes. 4. Measure belt tension:

[a] If tension is 445 N (100 lb) or more, no tensioning is required. [b] If tension is less than 445 N (100 lb), retension the belt to 445 N (100 lb). 5. Check belt tension every 100 hours or 12,000 km (7,500 miles). Refer to section 14.6.9 and retension if necessary. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-15