Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL [a] If tension is 667 N (150 lb) or more, no tensioning is required. [b] If tension is less than 667 N (150 lb), adjust the belt tension to 667 N (150 lb). 5. Check belt tension every 100 hours or every 12,000 km (7,500 miles). Refer to section 14.6.9 and re-tension 667 N (150 lb), if necessary. Powerband® is a registered trademark of the Gates Rubber Company. 9.2.3.4 Checking Belt Tension on a 6 – Rib Poly-vee Alternator Drive Belt The recommended tension for a new belt is 978 N (220 lb). However, because a new belt loses tension rapidly during the first few minutes of operation, it is important to check the tension after running the engine for 10 to 15 minutes.

To check belt tension use the following procedure: NOTICE: Failure to properly orient the drive belt when installing it over the pulleys may result in belt damage at engine startup. 1. Tension the new drive belts to 978 N (220 lb) using appropriate belt tension gage. 2. Refer to section9.2.3.1 for exhaust caution before preceding. Start and run the engine for 10 to 15 minutes to allow the belts to warm up and seat in the pulley grooves. 3. Stop the engine, and allow it to cool for 10 to 15 minutes. 4. Measure belt tension: [a] If tension is 800 N (180 lb) or more, no tensioning is required. [b] If tension is less than 800 N (180 lb), adjust the belt tension to 800 N (180 lb). 5.

Check belt tension every 100 hours or every 12, 000 km (7,500 miles). Refer to section 14.6.9 and re-tension to 800 N (180 lb), if necessary. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-17