SERIES 60 SERVICE MANUAL INSTALLATION OF THE IMPROVED VENT LINE The improved vent line is installed between the alternator case and the drive belt auto-tensioner mounting plate on the gear case cover. Existing Series 60 engines with auto tensioner assemblies and engines with former manual drive belt tensioner assemblies may be modified to accept the improved vent line. Use the following procedures: PERSONAL INJURY To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. PERSONAL INJURY To avoid injury from accidental engine startup while servicing the engine, disconnect/disable the starting system.
Installation of Vent Line in Drive Belt Auto Tensioner Assembly Mounting Plate On engines with current drive belt auto tensioner assemblies, install the improved vent line between the alternator and the tensioner mounting plate as follows: 1. With the engine at ambient temperature and cool to the touch, remove and discard the former alternator vent line. Plug the vent line hole at the back of the gear case with a 1/4 in. NPTF square socket head pipe plug. 2. Remove the former vent fitting from the top of the alternator case. 3. Install the 3/8 in. flared to 1/4 in. NPTF, 90 degree elbow into the top of the alternator case. 4. Remove the alternator drive belt. Refer to section 9.2.2. 5.
Remove the drive belt auto tensioner assembly from the mounting plate on the gear case cover. 6. Remove the mounting plate from the gear case cover. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-19