9.2 BATTERY CHARGING ALTERNATOR To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. PERSONAL INJURY PERSONAL INJURY To avoid injury from accidental engine startup while servicing the engine, disconnect/disable the starting system. 1. With the engine at ambient temperature and cool to the touch, remove and discard the former alternator vent line. Plug the vent line hole at the back of the gear case with a 1/4 in. NPTF square socket head pipe plug. 2. Remove the former vent fitting from the top of the alternator case. 3. Install the 3/8 in. flared to 1/4 in. NPTF, 90 degree elbow into the top of the alternator case. 4.
Remove the alternator drive belt. Refer to section 9.2.2. 5. Remove the manual belt tensioner assembly from the gear case cover. 6. Remove the front camshaft cover from the gear case cover. 7. The center hole in the cover has a 1/8 in. NPTF thread which must be enlarged. Using a 0.425 in. drill bit, carefully drill out the tapped hole. Thread the hole with a 1/4 in. NPTF - 4FF tap. See Figure 9-12. Figure 9-12 Drilled and Tapped Vent Line Hole in Front Camshaft Cover (Rev. 2005) All information subject to change without notice. 9-22 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION