SERIES 60 SERVICE MANUAL NOTICE: Do not drop the bolt or washer into the gear set. Engine or REPTO damage will occur. 7. Using a magnetic socket, install and torque all eleven flywheel housing mounting bolts in sequence to 112–126 N·m (83–93 lb·ft.) for 12 mm bolts or 160–200 N·m (118–148 lb·ft.) for 14 mm bolts. See Figure 10-17. NOTE: Ensure that the three bolts behind plugs are not overlooked in this step. Figure 10-17 Flywheel Housing Bolt Location and Torque Sequence All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 10-21