Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 11.1.3 Installation of Adaptorless Air Compressor Install the adaptorless air compressor as follows: 1. Clean all gasket material from the mating surfaces of the air compressor and the gear case. 2. Align the reference mark on the fuel pump drive coupling to the nine o'clock position. This will set the air compressor piston at top dead center and will help to ease the process of checking gear lash. 3. Using a new gasket and bolts and nut previously removed, install the air compressor to its original location on the gear case. NOTE: The shorter bolt is installed in the two o'clock position and the nut is installed in the twelve o'clock position. 4.

For torquing sequence, see Figure 11-7. Use compressor wrench (J–35948) to torque the upper inside bolt. Using the bolt and nut torquing sequence, torque five bolts and one nut to 58–73 N·m (43–54 lb·ft). Figure 11-7 Bolt Torque Sequence All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 11-11