Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 11.2 AIR COMPRESSOR DRIVE HUB The air compressor crankshaft will turn while removing or tightening the drive hub retaining nut unless some provision is made to hold it. One method is to weld a modified drive coupling to a support or base which can be anchored to the mounting flange of the compressor. A Series 71 or 92 flywheel housing cover that matches the flange of the compressor makes an ideal base for the modified coupling. When positioned, the exterior splines of the coupling mesh with the internal splines of the drive hub and the assembly is secured to the compressor housing.

The shaft is then kept from rotating when the nut is loosened or tightened, by the hub and key. 11.2.1 Replacement of Air Compressor Drive Hub To replace the air compressor drive hub, perform the following procedure. See Figure 11-11. Figure 11-11 Flowchart for Replacement of Air Compressor Drive Hub 11.2.2 Removal of Air Compressor Drive Hub To keep the shaft from rotating, perform the following: All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 11-19