SERIES 60 SERVICE MANUAL 14.6.25 Crankcase Pressure Test Without Dynamometer To check crankcase pressure without a dynamometer a crankcase pressure sensor kit is available to measure crankcase pressure using existing vehicle wiring. The sensor is installed into the dipstick tube and plugged into the oil pressure sensor harness. The crankcase sensor is connected to the DDEC® ECM and will record the crankcase pressure as oil pressure readings used for conversion to kPa (inches of H 2 O). Assemble crankscase pressure components as follows: 1. Install three seals on crankcase pressure sensor adaptor. 2. Thread crankcase pressure sensor into adaptor. See Figure 14-11. 1.
Crankcase Pressure Sensor 3. Seals 2. Sensor Adaptor Tube 4. Sensor Harness Figure 14-11 Crankcase Pressure Sensor Kit Components To check crankcase pressure use the following procedure: 1. Remove the dipstick from the engine. 2. Insert adaptor into dipstick tube. 3. Connect crankcase pressure sensor harness to sensor and route harness over engine so as to avoid hot exhaust components. 4. Unplug the wiring harness from the oil pressure sensor on the left rear of the block, and plug the crankcase pressure sensor harness into the oil pressure sensor wiring. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 14-43