14.6 DESCRIPTION OF MAINTENANCE ITEMS 14.6.26 Fan Hub If the fan bearing hub assembly has a grease fitting, use a hand grease gun and lubricate the bearings with one shot of Mobilgrease® Hp, or an equivalent lithium-base multi-purpose grease every 160,000 km (100,000 miles) for vehicle engines. Care should be taken not to overfill the housing. Refer to OEM maintenance guidelines. Mobilgrease® is a registered trademark of the Mobil Corporation. 14.6.27 Thermostats and Seals Inspect the thermostats and seals every 24 months. Refer to section 4.4.2.1. The thermostats and seals should be replaced every 322,000 km (200,000 miles) for vehicle engines.
14.6.28 Intake System Because natural gas is mixed with the air before the turbocharger on the Series 60G engine, special precautions and inspections are required. Inspect the fuel system components (regulator, PSV, and mixer), intake ducting, turbocharger compressor connections, charge air cooler connections, throttle connections, and intake manifold connections for leaks. Any leak in the intake system downstream of the mixer will result in reduced engine performance and the possible release of a combustible mixture of fuel/air into the atmosphere. The charge air cooler should be tested for leaks as recommended by the manufacturer.
The throttle used on the Series 60G engine is fully enclosed, automatically calibrated at engine start up and requires no adjustment or maintenance. The throttle is serviced as a complete unit. 14.6.29 Crankcase Breather Remove the internally mounted (in the engine rocker cover for diesel engines and on front gear case cover for natural gas engines) crankcase breather assembly annually (vehicle engines) and wash the steel mesh pad in clean fuel oil. Refer to section 1.6.6. This cleaning period may be reduced or lengthened according to the severity of service. (Rev. 2005) All information subject to change without notice. 14-46 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION