14.6 DESCRIPTION OF MAINTENANCE ITEMS 14.6.30 Engine Tune-up There is no scheduled interval for performing an engine tune-up. As long as the engine performance is satisfactory, no tune-up should be needed. The valve lash and injector heights on Series 60 diesel-fueled engines must be measured and, if necessary, adjusted after the first 96,000 km (60,000 miles) or 24 month period, whichever comes first. Once the initial measurements and adjustments have been made, any changes beyond this point should be made only as required to maintain satisfactory engine performance. Refer to section 13.2 of this service manual for valve lash and injector height adjustment procedures. NOTICE:
Failure to measure valve clearances and injector heights at the required initial period and make necessary adjustments may result in gradual degradation of engine performance and reduced fuel combustion efficiency. The valve lash on Series 60G natural gas-fueled engines should be checked and adjusted as follows: Truck and Motor Coach Engines - Check every 58,000 km (36,000 miles) or 12 months, whichever comes first, and adjust if necessary. Refer to section 12.4 of this service manual for valve lash adjustment procedures. NOTICE:
Failure to measure valve lash at the required intervals and make necessary adjustments may result in gradual degradation of engine performance and reduced fuel combustion efficiency. (Rev. 2005) All information subject to change without notice. 14-48 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION