15.2 RESTORING AN EXTENDED STORAGE ENGINE 15.2 RESTORING AN EXTENDED STORAGE ENGINE Use the following procedure to restore an engine that has been in extended storage. 1. Remove the covers and tape from all of the openings of the engine, fuel tank and electrical equipment. Do not overlook the exhaust outlet. 2. Remove the plugs from the inlet and outlet fuel lines and connect the lines to their proper position. 3. Wash the exterior of the engine with fuel oil to remove the rust preventive. (Do NOT wash electrical components.) 4. Remove the rust preventive from the flywheel. 5. Remove the paper strips from between the pulleys and drive belts. 6.
Fill the crankcase to the proper level, with the recommended grade of lubricating oil listed in Table 15-2. Use a pressure lubricator to insure all bearings and rocker shafts are oiled. Table 15-2 Recommended Engine Oil (Rev. 2005) All information subject to change without notice. 15-10 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Specification Recommendation SAE Viscosity Grade 15W-40 API Classification CH - 4 Military Specification MIL-L-2104E HT/HS Viscosity 3.7 cP (minimum)