16.3 IGNITION COIL ASSEMBLY 16.3 IGNITION COIL ASSEMBLY The ignition coil assembly consists of the ignition coil and integral seal. This is serviced as an assembly, or the seal can be serviced separately. Before the coil can be installed into the engine, it is necessary to attach the boot, mounting screws, and O-rings onto the ignition coil assembly. See Figure 16-2. 1. Bolt, M6 x 1.0 in. (2) 4. Ignition Coil Assembly 2. O-ring (2) 5. Boot and Spring Assembly 3. Ignition Coil Seal Figure 16-2 Ignition Coil Assembly 16.3.1 Removal of Ignition Coil Remove the ignition coil as follows: 1. Remove the two Phillips screws holding the coil cover in the rocker cover. 2.
Remove the low voltage wire harness connectors at each coil to be removed. 3. Unscrew the two M6 x 1.0 bolts that attach the coil to the rocker cover. Pull the coil assembly with the boot, mounting screws, and O-rings out of the spark plug well. 4. Inspect the ignition coil. Refer to section 16.3.1.1. 16.3.1.1 Inspection of Ignition Coil Inspect the ignition coil as follows: (Rev. 2005) All information subject to change without notice. 16-6 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION