SERIES 60 SERVICE MANUAL 7. When the installer tool contacts the cylinder head, the seal is correctly positioned. Be sure the installer is square against the cylinder head. Remove the seal installer and protector cap. 8. Install the valve spring and rotator. See Figure 1-93. If reusing parts, install them to their original positions. 1. Valve Locks 4. Valve Stem Oil Seal 2. Valve Rotator 5. Valve Guide 3. Valve Spring 6. Valve Spring Seat Figure 1-93 Valve Spring and Related Parts 9. Using the valve spring compressor tool (J–8062), compress the valve spring only as much as required to install the valve locks.
After installing the valve locks, rap the end of the valve stem sharply with a plastic mallet to seat the valve locks. NOTE: Always install new valve stem locks when installing valves. NOTE: Be sure the valve rotator is properly centered and aligned to avoid scoring the valve stem. Do not compress the spring any more than necessary to install the locks, to avoid damaging the oil seal. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-103