SERIES 60 SERVICE MANUAL 11. Note the gage reading when the valve just starts to unseat. The force required to unseat the valve must not be less than 280 N (63 lb). 12. Remove the cylinder head from the overhaul stand and install it on the engine. Refer to section 1.2.5. 13. Install the camshaft and rocker arm assemblies. Lightly lubricate the overhead assemblies with clean engine oil. Refer to section 1.28.5. 14. If the engine is equipped with a Jake Brake®, install the brake. Refer to section 1.36.5. 15. Adjust the valve clearance and injector timing. Refer to section 13.2. 16. If the engine is equipped with a Jake Brake®, lash the brake. Refer to section 13.2. 17.
Install any other components that were removed. 18. Fill the engine crankcase (refer to section 14.6.1) with the proper lubricant. Refer to section 5.2.1. 19. Close any drain cocks that were opened and fill the cooling system. Refer to section 14.6.4. Purge the air from the system using the vent in the thermostat housing. Complete filling of the cooling system is essential for proper engine operation. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area.
If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 20. Start the engine and check for leaks. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-105