Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.8 CRANKSHAFT OIL SEALS 1.8.2 Removal of Front or Rear Crankshaft Oil Seal (Gear Case Cover or Flywheel Housing Removed) Perform the following procedures to remove the crankshaft seal from the gear case cover or flywheel housing if the cover or housing has been removed from the engine. NOTICE: Due to the possibility of damage to the crankshaft oil seals, any time the gear case cover or flywheel housing is removed from the engine, the crankshaft oil seals must be replaced. 1. Support the outer face of the gear case housing or flywheel housing on wood blocks. 2. Drive the oil seal out with a brass drift and hammer.

Clean the seal bore in the gear case cover or flywheel housing and clean the surfaces of the crankshaft. See Figure 1-133. Figure 1-133 Crankshaft Oil Seal Removal NOTE: Crocus cloth may be used to remove dirt and rust and to clean up the high spots from the surface of the crankshaft and gear case cover or flywheel housing bore. Clean the contact surfaces thoroughly. 3. If the crankshaft oil seal wear sleeve remains installed on the hub of the crankshaft, reinstall the gear case cover or flywheel housing. (Rev. 2005) All information subject to change without notice. 1-154 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION