Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.10.1 Repair or Replacement of Gear Case Cover To determine if repair is possible or replacement is necessary, perform the following procedure. See Figure 1-156. Figure 1-156 Flowchart for Repair or Replacement of Gear Case Cover 1.10.2 Removal of Engine Gear Case Cover With the engine mounted on an overhaul stand. Remove the gear case cover as follows: NOTICE: Do not hit the face of the damper to loosen it. Damage to the internal components may result. The oil pan cannot be used to support the front of the engine in a vehicle, as its thermoplastic construction will not support the weight. 1. Drain the engine oil and remove the engine oil pan.

Refer to section 14.6.1, for oil draining and refer to section 3.11.2. 2. Loosen the fan hub mounting bolts. Loosen the fan adjusting bolt. Back the adjuster off far enough to remove the drive belts. Remove the fan and fan hub assembly. Refer to section 4.6.2. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-179