SERIES 60 SERVICE MANUAL 1.11.1 Repair or Replacement of Gear Case Cover To determine if repair is possible or replacement is necessary, perform the following procedure. See Figure 1-175. Figure 1-175 Flowchart for Repair or Replacement of Gear Case Cover 1.11.2 Removal of Gear Case Cover With the engine on an overhaul stand, remove the gear case cover as follows: 1. Drain engine coolant. Refer to section 14.6.4. 2. Drain engine oil. Refer to section 14.6.1. 3. Loosen the fan hub mounting bolts. Loosen the fan adjusting bolt. Back the adjuster off far enough to remove the drive belts. Remove the fan and fan hub assembly. Refer to section 4.6.2.
All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-195