Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 11. Install a new front crankshaft seal. Refer to section 1.8.5. 12. Install vibration damper to crankshaft; refer to section 1.14.3. 13. Install crankshaft pulley; refer to section1.15.3.See Figure 1-187. 1. Bolt 3. Crankshaft Pulley 2. Washer 4. Vibration Damper Figure 1-187 Crankshaft Pulley and Vibration Damper 14. Rotate engine to TDC; install timing pin (J–45947) into slot in crankshaft. 15. Install camshaft gear assembly; refer to section 1.26.5. 16. Measure and adjust gear lash; refer to section 1.25.2.2. 17. Install rocker arm assemblies. Refer to section 1.3.3. 18. Adjust valve lash. Refer to section 13.2. 19. Install Jake Brake® assemblies.

Refer to section 1.36.5. 20. Adjust Jake Brake assemblies. Refer to section 1.36. 21. Install rocker covers; for one-piece refer to section 1.6.8; for two-and three-piece refer to section 1.6.9. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-207