1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) 1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) The gear case housing is constructed of cast iron, with machined mating surfaces, and is bolted to the front of the engine cylinder block. The gear case and gear case cover are bolted together to provide a sealed compartment for the engine gear train. See Figure 1-190. 1. Lifting Bracket 3. Gear Case Housing 2.
Gear Case Cover Figure 1-190 Gear Case and Gear Case Cover Pre EGR Several components are mounted to the gear case, including the adjustable idler gear assembly, see Figure 1-193, the fuel pump drive assembly, see Figure 1-194, the air compressor drive assembly or raw water pump drive assembly, see Figure 1-195; the water pump assembly (1991 and later engines) see Figure 1-196; and the camshaft thrust plate and drive gear assembly see Figure 1-213. In July 2001, new right and left side gear case stiffening brackets were added to provide: reduce engine noise, increase belt driven accessory life, reduce gear case vibration amplitude and reduce wear on the cam thrust plate perimeter seal.
See Figure 1-191 and see Figure 1-192. (Rev. 2005) All information subject to change without notice. 1-210 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION