1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) 1. Retaining Bolt 11. Oil Seal 2. Washer 12. Water Pump Housing O-ring 3. Water Pump Drive Gear 13. Drain Cock 4. Snap-ring 14. Water Pump Housing 5. Bearing Race 15. Water Pump Housing Pipe Plug 6. Bearing 16. Water Seal 7. Spacer Rings (2) 17. Impeller 8. Bearing 18. Water Pump Cover O-ring 10. Drive Shaft 20. Water Pump Cover Snap Ring 9. Bearing Race 19. Water Pump Cover Figure 1-196 Water Pump Assembly To eliminate the possibility of oil leakage at the adjustable idler gear stud location, Detroit Diesel recommends the following:
When rebuilding a Series 60 engine, or if the gear case is removed for any reason, the three original adjustable idler gear studs should be removed and replaced with new studs. Before pressing studs into the gear case, coat the shanks and underside of the stud heads with Loctite® No. 242 Sealant. This will prevent any oil leakage around the studs during engine operation. (Rev. 2005) All information subject to change without notice. 1-214 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION