Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.13 GEAR CASE EXHAUST GAS RECIRCULATION (EGR) MODEL Before pressing studs into the gear case, coat the shanks and underside of the stud heads with Loctite® No. 242 Sealant. This will prevent any oil leakage around the studs during engine operation. An opening is provided in the center of the gear case for the installation of the spindle and bull gear. See Figure 1-222. 1. Bull Gear 2. Spindle Figure 1-222 Bull Gear and Spindle Location (Rev. 2005) All information subject to change without notice. 1-234 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION