Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 4. Install the 14 gear case to cylinder block bolts. See Figure 1-230 for the bolt torque and torque sequence. Figure 1-230 Gear Case Torque and Torque Sequence 5. Remove the guide studs from cylinder block. 6. Inspect the bull gear, spindle and adjustable idler gear access opening in the gear case and remove any foreign material. 7. Rotate engine until cylinder No.1 is at TDC. 8. Install the spindle, torque the four bolts to 58-73 N·m (43-54 lb·ft) 9. Install adjustable idler gear. Refer to section 1.31.3. 10. Install bull gear. Refer to section 1.32.3. 11. Install the gear case cover. Refer to section.1.11.3 All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-241