Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.19 PISTON AND PISTON RING 1.19.6 Assembly of Series 60G Piston Rings Install the oil control ring for the Series 60G engine as follows: 1. Install the expander in the bottom groove of the piston. 2. Install the upper and lower rails ensuring one is on the upper side of the expander and the other is on the lower side of the expander. NOTE: The expander and both rails may be installed with either side up. There is no "football" mark on any of the three oil ring components for natural gas engines. 3. Orient the ring gaps of the rails 180 degrees apart so that they align with the paint marks on the expander. The expander should be 90 degrees from the oil ring gaps.

Install the compression and fire ring for the Series 60G engine as follows: 1. Install the compression ring (rectangular cut shape) in the second groove of the piston, using a piston ring expander tool.See Figure 1-281. Figure 1-281 Installation of Compression Ring 2. Install the fire ring in the top groove of the piston, using a piston ring expander tool. (Rev. 2005) All information subject to change without notice. 1-304 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION