1.20 ONE-PIECE PISTON ASSEMBLY AND PISTON RING The fire and compression rings are installed with the “identification” mark facing up, see Figure 1-286. Figure 1-286 Fire and Compression Ring Identification A one-piece oil control ring is used in the third groove. The expander is of Spira-Lox construction. Figure 1-287 Solid Core Piston Pin Cross Section The one-piece piston assembly uses a floating piston pin which rides on the one-piece bushing pressed into the end of the connecting rod. The original closed end connecting rod and solid core piston pin do not have drilled center orifices for lubrication.
Oil for lubrication and steel piston cooling is supplied by oil spray from piston cooling nozzles at the bottom of each piston bore. For model year 2000 engines, an oil passage was incorporated into the connecting rod design to improve lubrication to the piston pin. (Rev. 2005) All information subject to change without notice. 1-308 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION