Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.21 PISTON AND CONNECTING ROD ASSEMBLY 14. With the crankshaft throw in the bottom position, ensure the number on the connecting rod is towards the cooler side of the engine, place the ring compressor and the piston and connecting rod assembly over the cylinder where it is to be installed. See Figure 1-307. Figure 1-307 Connecting Rod Indexing NOTE: There are orientation lugs cast into one side of the upper and lower sections of the connecting rod. These orientation lugs face the front of the engine. See Figure 1-308. Figure 1-308 Orientation Lugs (Rev. 2005) All information subject to change without notice. 1-334 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION