SERIES 60 SERVICE MANUAL The oil hole through the upper bearing shell supplies oil to the oil passage in the connecting rod, thereby providing a supply of lubricating oil from the crankshaft to the connecting rod bearings, piston-pin bushing, and underside of the piston dome. The upper shell is grooved from one edge to the oil hole. The lower shell has a full-length (180 degree) groove. See Figure 1-320. Figure 1-320 Connecting Rod Bearing Detail (Open-End Rod) The connecting rods bearing caps are numbered according to the cylinder position with matching numbers stamped on the connecting rod tang side.
The current, wider connecting rod bearings replaced the former connecting rod bearings as listed in Table 1-25. This change was made to improve oil film thickness and reduce bearing pressures. The current bearings are 47.44-47.14 mm (1.868-1.856 in.) wide. The former bearings were 43.44-43.13 mm (1.710-1.698 in.) wide. To provide full support for the wider bearings, new connecting rods with smaller rod chamfers and current crankshafts with smaller fillet radii were also released. Refer to section 1.7 for information on the current crankshafts. NOTE: The current connecting rod bearings, connecting rods, and crankshafts must be used together to ensure interchangeability.
Former parts cannot be mixed with new parts in the same engine. The former bearing shells will be available for engines built prior to the unit serial numbers as listed in Table 1-7. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-347