SERIES 60 SERVICE MANUAL connecting rods can be mixed within an engine with the former non-drilled connecting rod. See Figure 1-321. Figure 1-321 Current and Former Closed-End Connecting Rods 1. Connecting Rod Nut (2) 4. Connecting Rod Bearing Cap 2. Notched Bolt (2) 5. Bearing Shells 3. Connecting Rod Figure 1-322 Connecting Rod and Bearing Shells (Closed-end Rod) The upper end of the rod has a pressed-in, machined bushing with two scallops, 180 degrees apart. Spray oil entering these scallops lubricates the piston pin and bushing during engine operation. The piston pin floats in the bushings of both the piston and the connecting rod. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-349