Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Closed-end connecting rods prior to model year 2000 have no center-drilled lubricating oil passage. See Figure 1-323, and see Figure 1-324. Figure 1-323 Connecting Rod Bearing Detail (Closed End Rod Without a Drilled Passage) Figure 1-324 Connecting Rod Bearings for 14 L and 12.7 L Engines The connecting rod bearing caps are numbered according to the cylinder position with matching numbers stamped on the connecting rod tang side. The connecting rod bearing shells are precision made and are of the replaceable type. The upper bearing shell is seated in the connecting rod and a lower bearing shell is seated in the connecting rod cap.

The upper and lower bearings are identical . The upper and lower bearing shells are located in the connecting rod by a tang at the parting line at one end of each bearing shell. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-351