Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL [b] If the connecting rod bearing-to-journal clearance exceeds 0.152 mm (0.006 in.) with used parts, replace with a new bearing. NOTE: The current bearing shells for 14 L engines and 12.7 L engines for model year 2000 have an oil hole in them to allow oil to flow into the connecting rod.See Figure 1-327 Figure 1-327 Connecting Rod Bearings for 14 L and 12.7 L Engines NOTE: Before installing the bearings, inspect the crankshaft journals. Refer to section 1.7.2.4. Do NOT replace one connecting rod bearing shell alone. If one bearing shell requires replacement, install both new upper and lower bearing shells.

Also, if a new or reground crankshaft is to be used, install all new bearing shells. NOTE: Bearing shells are NOT reworkable from one undersize to another under any circumstances. Bearing shells are available in 0.254, 0.508 and 0.762 mm (approximately 0.010, 0.020, and 0.030 in.) undersize for service with reground crankshafts. The bearing size specifications are listed in Table 1-25. 1.22.5 Installation of Connecting Rod Refer to section 1.21.5 to install the piston and connecting rod assembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-359