Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.24 GEAR TRAIN AND ENGINE TIMING The camshaft idler gear is mounted to the rear of the bull gear on the same carrier, and rotates along with the bull gear at the same speed. This camshaft idler gear drives the adjustable idler gear, which in turn, drives the camshaft drive gear. See Figure 1-340. 1. Bull Gear Retaining Nut 14. Camshaft Drive Gear Hub Key 2. Timing Pin 15. Camshaft Thrust Plate Seal 3. Bull Gear 16. Adjustable Idler Gear Hub Retaining Stud 4. Adjustable Idler Gear Retaining (3) Locknut 17. Bull Gear and Idler Gear Hub 5. Adjustable Idler Gear Plate 18. Bull Gear Hub Retaining (4) Bolt 6. Adjustable Idler Gear 19. Crankshaft Timing Gear 7. Camshaft Retaining Bolt 20.

Camshaft Idler Gear 8. Adjustable Idler Gear Hub 21. Bull Gear and Idler Gear Key 9. Thrust Plate Retaining (2) Bolt 22. Spacer 10. Camshaft Drive Gear 23. Bull Gear and Idler Gear Carrier 11. Camshaft Thrust Plate 24. Bull Gear and Idler Gear Bearings 12. Camshaft Thrust Plate Seal O-ring 25. Crankshaft Timing Rings 13. Camshaft Drive Gear Hub Figure 1-340 Gear Train and Related Parts The bull gear and camshaft idler gear are a press-fit to the bull gear and camshaft idler gear carrier. Both gears are keyed to the carrier by the same key. The carrier is supported by two tapered roller bearings, which ride on a hub bolted to the engine block by four bolts.

The bull gear and camshaft idler gear assembly is retained to the hub by a left-hand threaded nut . The camshaft idler gear drives the camshaft drive gear through an adjustable idler gear. The adjustable idler gear is supported by a bushing and is mounted on an adjustable hub secured by three studs pressed into the gear case from the rear. (Rev. 2005) All information subject to change without notice. 1-374 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION