SERIES 60 SERVICE MANUAL These two holes are connected to the main oil gallery. The adjustable idler gear assembly is pressure-fed by an oil gallery in the gear case that indexes with a hole in the engine block. The hole in the engine block is connected to the main oil gallery. The correct relationship between the crankshaft and the camshaft must be maintained to properly control the opening and closing of the intake and exhaust valves, and the operation of the fuel injectors and to help maintain engine balance. The crankshaft and camshaft gears can only be mounted in one position as they are both keyed to their mating parts.
Therefore, when the engine is properly timed, the timing marks on the various gears will match. See Figure 1-341. An "out of time" engine may result in valve-to-piston dome contact, a no-start condition or loss of power. 1.24.1 Repair or Replacement of Gear Train and Engine Timing To determine if repair is possible or replacement is necessary, perform the following procedure. See Figure 1-343. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-377