1.24 GEAR TRAIN AND ENGINE TIMING 3. Check the crankshaft timing gear-to-bull gear lash measurement as follows: [a] Install a dial indicator and magnetic base. See Figure 1-348. Figure 1-348 Crankshaft Timing Gear-to-Bull Gear Lash Measurement [b] Adjust the stem of the dial indicator to rest on the center of a tooth on the bull gear. [c] Preload the bull gear. [d] Zero the dial indicator pointer. [e] Hold the crankshaft timing gear stationary with one hand. Rotate the bull gear and check the total gear lash in four positions of crank gear, approximately 90 degrees apart. [f] Although gear lash for the remaining gear sets is not adjustable, the lash must still be measured.
Lash specifications is 0.051-0.229 mm (0.002 -0.009 in.) for new parts and a maximum of 0.305 mm (0.012 in.) for used parts. [g] If lash measurement is exceeded, replace gear with a new part. (Rev. 2005) All information subject to change without notice. 1-384 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION