1.25 COMPACT GEAR TRAIN AND ENGINE TIMING The camshaft gear assembly must be in time with the crankshaft timing gear. Since there are three gears between them, timing marks have been stamped or etched on the face of the crankshaft timing gear and bull gear to facilitate correct gear train timing. There are no timing marks on the drive gears for the air compressor and power steering pump, water pump, accessory drive pulley, adjustable idler gear or camshaft drive gear. Therefore it is not necessary to align these gears in any particular position during installation..
The lash between the various mating gears in the gear train should be 0.051 - 0.229 mm (0.002 - 0.009 in.) and should not exceed 0.305 mm (0.012 in.) backlash between worn gears. Gear train noise is usually an indication of excessive gear lash, chipped, pitted or burred gear teeth or excessive bearing wear. Therefore, when noise develops in a gear train, the gear case cover should be removed and the gear train and its bearings inspected. A rattling noise usually indicates excessive gear lash whereas a whining noise indicates too little gear lash.
The correct relationship between the crankshaft and the camshaft must be maintained to properly control the opening and closing of the intake and exhaust valves, the operation of the fuel injectors and to help maintain engine balance. An “out of time” engine may result in valve-to-piston dome contact, a no-start condition or loss of power. 1.25.1 Repair or Replacement of Gear Train and Engine Timing To determine if repair is possible or replacement is necessary, perform the following procedure. See Figures 1-360, 1-361 and 1-362. (Rev. 2005) All information subject to change without notice. 1-400 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION