Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.25 COMPACT GEAR TRAIN AND ENGINE TIMING [a] Fasten a dial indicator and magnetic base to the cylinder block so that the stem of the dial indicator rests on a tooth of the oil pump drive gear. See Figure 1-364. Figure 1-364 Crankshaft Timing Gear-to-Oil Pump Idler Gear Lash Measurement [b] Hold the crankshaft timing gear stationary, and rotate the oil pump drive gear in one direction, as far as it will go, without moving the crankshaft timing gear. [c] Zero the dial indicator. [d] Move the oil pump drive gear in the opposite direction, as far as it will go, without moving the crankshaft timing gear. [e] Read and record the total gear lash. NOTE:

The gear lash must be checked in four positions 90 degrees apart. NOTE: The lash between the crankshaft timing gear and oil pump drive gear must be measured with the engine assembled and positioned to run. See Figure 1-364. (Rev. 2005) All information subject to change without notice. 1-406 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION