Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.26 CAMSHAFT GEAR ASSEMBLY SERIES 60 EXHAUST GAS RECIRCULATION (EGR) MODEL The No. 4 camshaft cap is secured to the cylinder head with three bolts; cap numbers 2, 3, 5, and 6 use two bolts each. Caps one and seven have a stud and one bolt each. The stud and nut arrangement on the end caps (1 and 7) allows rocker arm shaft removal without disturbing the gasket eliminator seal from the end camshaft caps to the cylinder head. There are four different camshaft cap configurations. Only the intermediate caps No. 2, 3, 5, and 6 are identical but must not be interchanged during re-assembly. See Figure 1-376. 1. Camshaft Cap Bolt (13) 2.

Camshaft Cap Stud and Nut (2) Figure 1-376 Camshaft Bolt and Cap Location NOTE: Caps are NOT interchangeable once the head is finished. Caps are numbered and must NOT be interchanged with other caps of the same part number from stock or from a different cylinder head. See Figure 1-375. (Rev. 2005) All information subject to change without notice. 1-420 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION